Updating The Server Configuration - IBM System x3200 Installation Manual

Updating the server configuration

When you start the server for the first time after you add or remove an internal or
external device, you might receive a message that the configuration has changed.
The Configuration/Setup Utility program starts automatically so that you can save
the new configuration settings. See Chapter 4, "Configuring the server," on page 43
for additional information.
Some devices have device drivers that you must install. For information about
installing device drivers, see the documentation that comes with each device.
If the server has a ServeRAID adapter and you have installed or removed a hard
disk drive, see the ServeRAID documentation that comes with the server for
information about reconfiguring the disk arrays.
36
System x3200 Type 4362 and 4363: Installation Guide