IBM System x3200 Installation Manual page 64

50
System x3200 Type 4362 and 4363: Installation Guide
Table 4. Abbreviated list of POST error codes (continued)
v Follow the suggested actions in the order in which they are listed in the Action
column until the problem is solved.
v See the parts listing in the Problem Determination and Service Guide to determine
which components are customer replaceable units (CRU) and which components
are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must
be performed only by a trained service technician.
Error code Description
175 Service processor flash code
damaged or not loaded.
Note: In this case, the service
processor is the optional Remote
Supervisor Adapter II SlimLine.
184 Power-on password damaged.
187 VPD serial number not set.
189 Three attempts were made to
access the server with an incorrect
password.
289 A DIMM has been disabled by the
system.
Action
1. Update the Remote Supervisor
Adapter II SlimLine firmware
(see the Problem
Determination and Service
Guide on the IBM System x
Documentation CD).
2. Replace the Remote
Supervisor Adapter II SlimLine.
1. Run the Configuration/Setup
Utility program, select Load
Default Settings, and save the
settings.
2. Reseat the battery.
3. Replace the following
components one at a time, in
the order shown, restarting the
server each time:
a. Battery
b. (Trained service technician
only) System board
1. Set the serial number by
updating the BIOS code level
(see the Problem
Determination and Service
Guide on the IBM System x
Documentation CD).
2. (Trained service technician
only) Replace the system
board.
Restart the server and enter the
administrator password; then, run
the Configuration/Setup Utility
program and change the power-on
password.
1. Make sure that the DIMM is
installed correctly (see
"Installing a memory module"
on page 13).
2. Replace the DIMM.
3. (Trained service technician
only) Replace the system
board.