Features And Specifications - IBM System x3200 Installation Manual

Features and specifications

The following information is a summary of the features and specifications of the
server. Depending on the server model, some features might not be available, or
some specifications might not apply.
Table 1. Features and specifications
Microprocessor:
® ™
v One Intel Xeon 3000 sequence or
Pentium D microprocessor, dual-core
or quad-core
Important: Do not mix dual-core and
quad-core microprocessors in the
same system.
v 2 MB or 4 MB Level-2 cache
v 800 or 1066 MHz front-side bus
(FSB)
Memory:
v Minimum: 512 MB
v Maximum: 8 GB
v Types: PC2-5300 double-data-rate 2
(DDR2)
v Connectors: four dual inline memory
module (DIMM) connectors, two-way
interleaved
Drives (depending on the model):
v Diskette (optional internal or external
USB): 1.44 MB
v Hard disk drive: SAS or SATA
v One of the following optical IDE
drives:
– CD-ROM
– DVD-ROM (optional)
– DVD-ROM/CD-RW (optional)
– Multiburner (optional)
Drive bays (depending on the
model):
v Two 5.25 in. bays (one optical drive
installed)
v One 3.5 in. removable-media drive
bay
v Four 3.5 in. or 2.5 in. hard disk drive
bays
PCI expansion slots (depending on
the model):
v One PCI Express x8 slot
v One PCI Express x1 slot
v Three PCI 32-bit/33 MHz slots
Fans:
Three speed-controlled fans.
Power supply:
One of the following:
v Two redundant 430 watt (90-240 V ac)
v One nonredundant 400 watt (90-240 V
ac)
Size:
v Height: 438 mm (17.25 in.)
v Depth: 540 mm (21.25 in.)
v Width: 216 mm (8.5 in.)
v Weight: 16.3 kg (36 lb) to 25.2 kg (56
lb) depending upon configuration
Integrated functions:
v Mini baseboard management controller
(mini-BMC)
v Broadcom BCM5721 10/100/1000
Ethernet controller on the system board
with RJ-45 Ethernet port
v Two serial ports
v One parallel port
v Four-port Serial ATA controller
v One internal SAS port (mini-PCI slot)
v Six Universal Serial Bus (USB) v2.0
ports (two on front and four on rear)
v Keyboard port
v Mouse port
v ATA-100 single-channel IDE controller
(bus mastering)
v ATI ES1000 video controller
– Compatible with SVGA and VGA
– 16 MB SDRAM video memory
Diagnostic LEDs:
v Fans
v Memory
v Power supply
Acoustical noise emissions:
v Sound power, idling: 5.0 bel
v Sound power, operating: 5.3 bel
Environment:
v Air temperature:
– Server on: 10° to 35°C (50° to 95°F)
Altitude: 0 to 914 m (2998.0 ft)
– Server off: -40° to 60°C (-40° to 140°F)
Altitude: 0 to 2133 m (7000.0 ft)
v Humidity (operating and storage): 8% to
80%
Heat output:
Approximate heat output in British thermal
units (Btu) per hour:
v Minimum configuration: 630 Btu per hour
(185 watts)
v Maximum configuration: 1784 Btu per hour
(523 watts)
Electrical input:
v Sine-wave input (50 or 60 Hz) required
v Input voltage and frequency ranges
automatically selected
v Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
v Input voltage high range:
– Minimum: 200 V ac
– Maximum: 240 V ac
v Input kilovolt-amperes (kVA) approximately:
– Minimum: 0.20 kVA (all models)
– Maximum: 0.55 kVA
Notes:
1. Power consumption and heat output vary
depending on the number and type of
optional features installed and the
power-management optional features in
use.
2. These levels were measured in controlled
acoustical environments according to the
procedures specified by the American
National Standards Institute (ANSI) S12.10
and ISO 7779 and are reported in
accordance with ISO 9296. Actual
sound-pressure levels in a given location
might exceed the average values stated
because of room reflections and other
nearby noise sources. The declared
sound-power levels indicate an upper limit,
below which a large number of computers
will operate.
Chapter 1. Introduction
5