DigiDesign 3 Getting Started Manual page 97

Press the Channel Select switch under a
3
plug-in name.
Press the Plug-In Master Bypass switch.
4
To bypass all plug-ins on a channel:
Press the Insert switch (Channel View section)
1
to put 003 in Channel View.
Press a lit Channel Select switch to display the
2
inserts for the corresponding track.
Press the Plug-In Master Bypass switch.
3
In mixed mode situations, where some plug-ins
are bypassed and some are not, pressing the
Master Bypass switch changes all plug-ins to by-
passed. Press Master Bypass again to take all
plug-ins out of bypass.
Hardware I/O inserts cannot be bypassed in
Pro Tools, so the Plug-in Master Bypass
switch has no effect on them.
Pan/Send Workflows in Channel
View
When the Pan/Send switch is enabled (lit), 003
identifies channels with sends assigned to them
by illuminating their Channel Select switches. If
no sends are present for the current bank of
channels, no Channel Select switches will be lit.
In this view, you can display sends, adjust send
levels, and toggle pre- and post-fader operation.
To display the sends on a track:
Press the Pan/Send switch to put 003 in Chan-
1
nel View.
Press a lit Channel Select switch.
2
Do one of the following:
3
• To display Sends A–E, press the Left Page
switch.
• To display Sends F–J, press the Right Page
switch.
The LCD display for the first channel strip
shows track pan position for that track. (If the
track is a stereo track, you can toggle between
left and right pan by pressing the Meter switch
immediately to the right of the rotary encoders.)
The LCD display for channels 3–7 shows the
send names. Their rotary encoders control the
levels for the corresponding send.
The Channel Select switches on channels 3–7
toggle pre- and post-fader metering for the cor-
responding send.
To adjust send levels for any of the sends on a
single track:
Press the Pan/Send switch in the Channel
1
View switch section.
Press the Channel Select switch for the track
2
with sends you want to view.
Adjust a channel's send level by turning its ro-
3
tary encoder.
To adjust pan levels on a track that has sends:
Press the Pan/Send switch in the Channel
1
View switch section.
Press the Channel Select switch for the track
2
with sends that has panning you want to adjust.
Do one of the following:
3
• If the track is a stereo track, toggle the
Meter switch to Left or Right.
– or –
• If the track is a mono track, toggle the
Meter switch to Left.
Chapter 11: Pro Tools Mode with 003 89