Electrical Installation - Da-Lite Contour Electrol Instruction Book

ELECTRICAL INSTALLATION

1. open the junction box on the left end of the case using a #2
Phillips screwdriver. Install electrical connections that apply
to your unit. Make sure to review the wiring diagram for
proper hook up. Replace the junction box cover.
NoTe: Must be installed in accordance with the
requirements of the Local Building Codes, the Canadian
electrical Code (CeC), CAN/CSA C22.1 and the National
electric Code (NeC), NFPA 70.
2. Test installation by running screen up and down a few times.
Be prepared to stop screen should any objects obstruct the
movement of the screen. To prevent damage to the motor,
the standard duty cycle is 1 minute on and 3 minutes off.
4
Junction
Box Cover
Figure 5