Ceiling Flush Mount - Da-Lite Contour Electrol Instruction Book

INSTALLATION (continued)
3. Make sure the bracket is level.
4. Hang the screen case on the wall mount bracket as shown
in Figure 2. Be sure the case is fully seated on the bracket.
5. Tighten the two stop screws against the wall mount bracket
using a #2 Phillips screwdriver (Figure 1).

Ceiling Flush Mount

1. The ceiling hook brackets are attached to the top side of the
housing. They must be removed prior to ceiling flush mount.
NoTe: Do not remove the wall mount bracket, even if you
are not using it for mounting. This provides structural
stability to the case.
2. Using a #2 Phillips screwdriver, loosen the four 1/4"x 5/8"
screws holding the ceiling flush mount brackets (Figure 3).
3. Slide the ceiling flush mount brackets so that the mounting
holes extend beyond the ends of the case. All four 1/4"x
5/8" screws must remain within the channels.
4. Tighten the four 1/4"x 5/8" screws holding the ceiling flush
mount brackets (Figure 3).
5. Before mounting your Contour electrol, be sure the ceiling
has adequate reinforcement.
6. Hold the screen case up to the ceiling and mark the hole
locations. The brackets have a set of front holes and a set of
rear holes. Attach the Contour electrol using the appropriate
hardware for your ceiling type. It is best to use at least one
hole in each set.
Ceiling hook Mount
1. The ceiling hook mount brackets are tied together and
attached to the ceiling flush mount bracket at one end of the
case. Remove the ceiling hook mount brackets.
2. Remove the ceiling flush mount brackets using a #2 Phillips
screwdriver (Figure 3). Retain four 1/4"x 5/8" screws.
Note: Do not remove the wall mount bracket, even if you are
not using it for mounting. This provides structural stability to
the case.
3. The top of the screen case has two channels with
threaded nuts that slide the length of the case. Attach the
two ceiling hook mount brackets using the 1/4"x 5/8"
screws and threaded nuts, two per bracket. The brackets
can be attached anywhere within 12" of the ends of the
case (Figure 4).
4. Before hanging your Contour electrol, be sure the ceiling has
adequate reinforcement.
5. Using the holes in the ceiling hook brackets, hang the
Contour electrol using the appropriate hardware and
fasteners for your ceiling type.
Wall
Wall Mount
Bracket
Figure 2
1/4 X 5/8"
Flat Head Screw
Figure 3
Ceiling Hook Bracket
1/4 X 5/8" Flat
Head Screw
Figure 4
3