Multi Media Card (Mmc) / Secure Device (Sd) Card - Motorola MC9090-G Manual

2 - 4 MC9090-G RFID Integrator Guide Supplement
Installing the Keypad
Figure 2-2
Perform a cold boot (see
4.

Multi Media Card (MMC) / Secure Device (SD) Card

The MMC provides secondary non-volatile storage. The MMC is located under the keypad (see
2-3).
NOTE SD cards are inter-operable with MMC cards and can also be used in MC9090-G RFID mobile
computers.
CAUTION
To insert the MMC/SD card:
Press the Power button to suspend the mobile computer.
1.
Remove the two keypad screws and slide the keypad down and lift off (see
2.
Lift the MMC/SD retaining door.
3.
Position the MMC/SD card, with the contacts down, into the MMC/SD holder. The MMC/SD card corner notch
4.
fits into the holder only one way.
Snap the retaining door closed.
5.
Performing a Cold Boot on page
Do not remove the keypad while the mobile computer is on and do not operate the mobile computer
with the keypad detached. Follow proper ESD precautions to avoid damaging the MMC/SD. Proper
ESD precautions include, but are not limited to, working on an ESD mat and ensuring that the
operator is properly grounded.
1-9).
Figure 2-1 on page
Figure 2-1 on page
2-3).