Motorola MC9090-G Manual page 81

Troubleshooting the RFID reader (Continued)
Table 7-1
Problem
The RFID reader does
not accept scan input.
Cause
Scanning application Verify that the unit is loaded with a scanning application. See the
is not loaded. System Administrator.
Unreadable bar code. Ensure the symbol is not defaced.
Distance between Ensure RFID reader is within proper scanning range.
exit window and bar
code is incorrect.
Mobile computer is Ensure the RFID reader is programmed to accept the type of bar
not programmed for code being scanned.
the bar code.
Mobile computer is If a beep on a good decode is expected and a beep is not heard,
not programmed to check that the application is set to generate a beep on good
generate a beep. decode.
Battery is low. If the scanner stops emitting a laser beam when the trigger is
pressed, check the battery level. When the battery is low, the
scanner shuts off before the mobile computer low battery
condition notification.
Note: If the scanner is still not reading symbols, contact the
distributor or Symbol Technologies.
Maintenance & Troubleshooting
Solution
7 - 5