Diagnostics; Diagnostic Chart; Diagnostic Memory - Ultra Start 3295Series Installation Manual

PAGE 31

DIAGNOSTICS

SYSTEM PROGRAMMING - Menu 1
DIAGNOSTICS CHART
If the remote starter does not activate when the start button is pressed the park lights will flash
a diagnostic to indicate what shutdown input has been triggered. For example: If the start
button is pressed the park lights flash 3 times slowly. Looking at the chart below this would
indicate that the system is in Service Mode, simply follow the instructions listed in the owners
manual on exiting Service Mode and the remote starter will begin to function as normal.
PARK LIGHTS
3 Slow Flashes
5 Flashes
5 Slow Flashes
6 Flashes
7 Flashes
8 Flashes
TO ENTER DIAGNOSTIC MEMORY
Step 1- Turn the ignition ON then OFF. Press and release the Program Button.
Step 2- The system will respond with three park light flashes and the HORN (optional) will honk the same
number of times as the events in memory.
****Maximum four events, four honks****
NOTE: If the HORN does not honk, there are no events in memory.
Step 3- Press the Program Button once to view the last shut down code. The HORN (optional)will honk
once to confirm code one.
****If the HORN does not honk, there are no codes in memory.****
Step 4- The LEDs on the antenna will flash a code corresponding to a shut down trigger. Press the
Program Button again for the second code.
***The HORN will honk twice to confirm code two three time for code three...***
Step 5- To Clear Diagnostic Memory. While in Diagnostic Mode press and hold the
Program Button for five seconds. The park lights will flash and the HORN (optional)
will honk once.
****Once diagnostic memory has 4 shutdown events in memory, the system will not record any further
shutdown events until the system memory has been cleared.****
LED Flashes
5 Flashes
6 Flashes
7 Flashes
8 Flashes
STATUS LED
LEDs "ON" Solid
Series of 5 Flashes
Series of 5 Flashes
Series of 6 Flashes
Series of 7 Flashes
Series of 8 Flashes
Diagnostic
The system was shutdown by the brake switch input
The system was shutdown by the hood pin input
The system did not detect the Tach signal.
The system made 3 start attempts without starting
95 SERIES
INSTALL MANUAL
DIAGNOSTIC CODE
System Is In Service Mode
Hood Open
Ignition On During Start Attempt
Brake Pedal Shutdown
Tach Lock-Out
3 Start Attempts Without Starting