Ultra Start 3295Series Installation Manual page 4

95 SERIES
INSTALL MANUAL
OUTPUT TO ACTIVATE DOOR LOCK CIRCUIT (-)
OUTPUT FOR VOLTAGE INVERTER*
OUTPUT TO ACTIVATE DOOR UNLOCK CIRCUIT (-)
PRE-WARN TRIGGER FOR ALARM MODELS (-)
FULL TRIGGER FOR ALARM MODELS (-)
GROUND OUTPUT FOR ADDITIONAL SENSOR (-)
12VOLT OUTPUT FOR ADDITIONAL SENSORS (+)
(-) WHILE RUNNING OUTPUT (BYPASS TURN ON)
GROUND OUTPUT FOR BYPASS MODULE
12VOLT OUTPUT FOR BYPASS MODULE
BYPASS MODULE DATA COMMUNICATION PORT***
*The default setting is for idatalink modules. For Fortin bypass modules power-
up the system with the Fortin module connected to the data port to set the default
to Fortin bypass module.
THERMISTOR/ INPUT TRIGGER TO START****
The thermistor can be installed in the engine compartment for engine temperature or in
under the dash for interior temperature.
SELECTABLE PARK LIGHT OUTPUT*****
BY DEFAULT THE SYSTEM COMES WITH
THE PARK LIGHT JUMPER SET FOR
POSITIVE PARK LIGHT OUTPUT. TO
CHANGE THE SYSTEM TO A NEGATIVE
PARK LIGHT OUTPUT, PLACE THE JUMPER
IN THE NEGATIVE PARK LIGHT POSITION
SHOWN IN THE DIAGRAM. (Position 2)
SYSTEM PROGRAMMING - Menu 1
QUICK VIEW WIRE DIAGRAM
GREEN
N/A*
BLUE
BLUE**
GREEN**
BLACK**
RED**
WHT/VIOLET
BLACK
RED
Position 1 or Position 2
POSITIVE
PARK LIGHT
PAGE 4
1
2
3
1
2
3
4
1
2
3
1
2
3
4
NEGATIVE
PARK LIGHT