Diagnostics; Diagnostic Memory - Ultra Start 25 series Install Manual

INSTALL MANUAL
PAGE 24

DIAGNOSTICS

If the remote starter does not activate when the start button is pressed the park
lights will flash a diagnostic to indicate what shutdown input has been triggered.
For example: If the
Looking at the chart below this would indicate that the system is in Service
Mode, simply follow the instructions listed in the owners manual on exiting
Service Mode and the remote starter will begin to function as normal.
PARK LIGHTS
3 Flashes
3 Slow Flashes
4 Slow Flashes
5 Flashes
5 Slow Flashes
6 Flashes
7 Flashes

DIAGNOSTIC MEMORY

LED Flashes
5 Flashes
6 Flashes
7 Flashes
8 Flashes
To Enter Diagnostic Memory Mode:
Step 1- Turn the ignition ON then OFF. Press and release the Program Button.
Step 2- The system will respond with three park light flashes and the horn (optional) will
honk the same number of times as the events in memory.
Maximum four events, four honks
NOTE: If the horn does not honk, there are no events in memory.
Step 3- Press the Program Button once to view the last shut down code. The horn (optional)
will honk once to confirm code one.
If the horn does not honk, there are no codes in memory.
Step 4- The LEDs on the antenna will flash a code corresponding to a shut down trigger.
Press the Program Button again for the second code.
The horn will honk twice to confirm code two.
Step 5- To Clear Diagnostic Memory. While in Diagnostic Mode press and hold the
Program Button for five seconds. The park lights will flash and the horn (optional)
will honk once.
NOTE: Once diagnostic memory has 4 shutdown events in memory, the system will not
Record any further shutdown events until the system memory has beencleared.
button is pressed the park lights flash 3 times slowly.
STATUS LED
Series of 3 Flashes
LEDs "ON" Solid
Series of 4 Flashes
Series of 5 Flashes
Series of 5 Flashes
Series of 6 Flashes
Series of 7 Flashes
Diagnostic
The system was shutdown by the brake switch input
The system was shutdown by the hood pin input
The system did not detect the tach signal.
The system made 3 start attempts without starting
REMOTE VEHICLE STARTER
DIAGNOSTIC CODE
Door Opened "M" Models
System Is In Service Mode
Not in Reservation Mode*
Hood Open
Ignition On During Start Attempt
Brake Pedal Shutdown
Tach Lock-Out
* "M" series ONLY