Ultra Start 3295Series Installation Manual page 13

PAGE 13
SYSTEM WIRING DETAILS
SYSTEM PROGRAMMING - Menu 1
1-YELLOW Re-arm(-) (Programmable)
Supplies one .75 second pulse when locked and one .75 second pulse after remote start shutdown. Factory
alarm re-arm/ RAP shutdown.
2-BROWN Dis-arm(-)
Supplies one .75 second pulse when the unlock button is pressed and one .75 second pulse before remote
start activation. For factory alarm dis-arm/ "wake up".
3-GRAY (-) Start/ Crank
Supplies a ground output at the same time as the positive starter output.
4-RED/WHITE Trunk Release(-) (Programmable)
Output will activate when the Unlock button is held for at least 3 seconds.
5- ORG/WHT 2nd Acc (-) / Auxiliary Output 2 (Programmable)
Ground output at the same time as the primary Accessory. output. This output can be programmed to activate
as and auxiliary output when the unlock and status buttons. (4 second output)
6- WHT/VIOLET Auxiliary Output 1/ Programmable Output
Auxiliary output when the unlock and trunk buttons are held (4 second output). Programmable (-) Ignition,
Dome Light Supervision
7- PINK Brake Switch input (+)
This wire must be connected to the wire at the brake switch that changes to 12volts when the brake is pressed.
8- BLACK/WHT N/A
9- GREEN/WHT Hood Pin Input (-)
Connect this wire to the supplied hood pin switch. If ground is detected on this input the remote starter will not
activate.
10- BLUE/WHT Tach Wire Input (A/C)
This wire is used to to detect when the vehicle has started. The Tach source is typically taken from a fuel
injector, coil, coil pack or crank position sensor. The Tach wire is generally found as the opposite from the
common wire at the coil or fuel injector.
11- BLUE Wait to Start Input (+ or -) (Programmable)
On diesel vehicles connect this wire to the wait to start or glow plug wire. The system will wait for the input to
turn off then remote start. A start delay may also be programmed to avoid this connection.
12- PURPLE Positive Door Input (+) ALARM MODELS
Connect this wire to the door pin switch if it changes to 12volts when the door is opened. *Connect to door pin
for Passive Arming on 1280 and 3285.
13- GREEN Negative Door Input (+) ALARM MODELS
Connect this wire to the door pin switch if it changes to Negative when the door is opened.
pin for Passive Arming on the 3295.
95 SERIES
INSTALL MANUAL
*Connect to door