Auto Tach Learning - Ultra Start 3295Series Installation Manual

PAGE 9
TACH / TACHLESS LEARNING
SYSTEM PROGRAMMING - Menu 1
AUTO TACH/ TACHLESS LEARNING
Start the vehicle with
the ignition key.
To Tach/ Tachless Learn the system simply start the vehicle with the ignition key. To confirm that
a proper Tach signal has been programmed the system will chirp the Horn/ Siren and flash the
park lights two times. If the tach wire is not connected the park lights will flash and the horn will
chirp 4 times to indicate Tachless Mode. NEW- If the vehicle does not have a 12 volt starter
wire let it run for 30-35 seconds. The LEDs will flash rapidly if a proper tach is detected
then turn off when the tach programs.
***The system must be Tach Learned before remote starting***
MANUAL TACH/ TACHLESS LEARNING
Hold the
brake
BRAKE
Press and Hold the brake pedal, Start the vehicle with the key then press and release the
program button then hold for 5 seconds. To confirm that a proper Tach signal has been
programmed the system will chirp the Horn/ Siren and flash the park lights two times. If the tach
wire is not connected the park lights will flash and the horn will chirp 4 times to indicate Tachless
Mode. If the Tach is not learned when the start button is pressed the park lights will flash 7 times.
***The system must be Tach Learned before remote starting***
TACH NOTES
* If Tach does not learn check for proper connection on the starter wire, ignition wire and at the
Tach connection. If the connections are good, reset the system and try again.
-For best results connect the Tach wire to a fuel injector wire.
* If the vehicle does not start when the remote starter is activated, the park lights will flash a
diagnostic code. (See Diagnostic Chart).
**If the vehicle still does not start, check all connections and check for a factory installed Anti-
Theft system. If the Anti-Theft prevents the vehicle from starting the remote start will flash the
park lights 7 times. The system does not have to be Tach learned if this happens, simply start
the vehicle with the key and let it run for 5 seconds then turn off.
2 CHIRPS
4 CHIRPS
Start the vehicle with
the ignition key.
SYSTEM PROGRAMMING - Menu 1
Horn/ Siren will chip to confirm that
the Tach/ Tachless has been programmed.
Horn/ Siren will chip to confirm
2 CHIRPS
that the Tach/ Tachless has been
4 CHIRPS
programmed.
95 SERIES
INSTALL MANUAL