Motorola XR450 - RFID Reader - Contactless Integration Manual page 57

Reader Configuration Window, Field Descriptions (Continued)
Table 3-4
Field
Disable Reader
Enable Read on Motion
Detection
Single Port TX/RX Mode check
box (XR450 and XR480 only)
Do Not Detect Motorola Light
Indicator Box
System Application
Set Advanced Parameters
Modify Reader
To modify the name and description of the reader, enter the information in the Name: and Description: fields.
3.
he serial number cannot be modified.
NOTE T
To read an additional payload on the tag during each read cycle, select a Memory Bank and enter Start word
4.
and Length in words to read. If Start and Length are 0, the entire bank is read.
To disable the reader, select the Disable Reader checkbox.
5.
To enable tag reads on motion detection, select the Enable Read on Motion Detection checkbox.
6.
To disable the light indicator box detection, select the Do Not Detect Motorola Light Indicator Box checkbox.
7.
To enable eight read points with each capable of TX/RX (on XR480 only) or 4 read points with TX/RX (on
8.
XR450 only), select the Single Port TX/RX Mode check box.
To configure the reader to use predefined application specific RF parameters select a suitable application from
9.
the System Application selection.
Note: Application specific parameters are internal and not configurable. Use Set Advanced Parameters for any
10.
customization.
To configure advanced parameters on the reader select Let me choose option under Set Advanced
11.
Parameters.
Click Modify Reader.
12.
The Disable Reader checkbox allows the administrator to disable the reader.
The Enable Motion Detector checkbox allows the administrator to enable tag reads
in autonomous mode when motion sensors are triggered, see
Input/Output on page 3-38.
The Single Port TX/RX Mode check box allows the administrator to enable RF
transmit and receive on each antenna port.
For XR 480:
All 8 ports are enabled and each capable of doing transmit/receive.
For XR450:
4 TX ports are enabled and each capable of transmit as well as receive.
RX ports are non-functional in this mode.
By default the reader performs Motorola Light Indicator Box detection at startup.
The Do Not Detect Motorola
Light Indicator Box checkbox allows the admin to disable this detection. GPIO lines
will still remain accessible for use even if this setting is turned on.
Administrator use this option to set the reader to internally use pre-defined
application specific parameters.
The Set Advanced Parameters radio button allows the administrator to customize
Q parameters for Gen 2.
The Modify Reader button saves the new configuration settings
Administrator Console 3 - 29
Description
General Purpose