Weider 9250 User Manual page 17

37. Wrap the Low Cable (69) around a 90mm Pulley
(15). Attach the Pulley and a pair of Pulley
Covers (40) to the middle hole in the Front
Upright (42) with an M10 x 120mm Bolt (95), an
M10 Washer (9), a Large Spacer (96), and an
M10 Nylon Locknut (21). Make sure the large
tabs on the Pulley Covers are on the side
shown.
38. Attach a 90mm Pulley (15) to the top hole in the
Swivel Bracket (81) with an M10 x 52mm Bolt
(103) and an M10 Nylon Locknut (21).
Locate the Carriage Cable (83), which has a ball
on one end and a eyelet on the other. Wrap the
Cable around a 90mm Pulley (15). Attach the
Pulley to the bottom hole in the Swivel Bracket
(81) with an M10 x 45mm Bolt (100) and an M10
Nylon Locknut (21).
39. Wrap the Carriage Cable (83) around a 90mm
Pulley (15) and route it through the hole in the
Carriage Upright (84). Attach the Pulley and a
pair of Pulley Covers (40) to the bracket on the
Carriage Upright with an M10 x 52mm Bolt (12)
and an M10 Nylon Locknut (21). Make sure the
large tabs on the Pulley Covers are on the
side shown.
40. Wrap the Carriage Cable (83) up around a 90mm
Pulley (15). Attach the Pulley and a pair of Pulley
Covers (40) inside the indicated bracket on the
Stabiliser (5) with an M10 x 115mm Bolt (102).
Push the Bolt only through the first bracket.
Make sure the large tabs on the Pulley Covers
are on the side shown.
Hold a 12.5mm Spacer (82) between the two
brackets on the Stabiliser (5). Push the M10 x
115mm Bolt (102) through the Spacer, but not
into the next bracket.
37
42
9
21
38
21
15
83
39
40
15
Large
Tab
40
Large
Tab
17
Large
40
Tab
96 40 15
69
81
100
21
83
84
12
40
40 15
83
40
102
82
5
95