Weider 9250 User Manual page 10

11. Press a 38mm Square Inner Cap (32) into the
end of the Seat Frame (36).
Attach the Bumper (87) to the Seat Frame (36)
with the M5 x 20mm Self-tapping Screw (80).
12. Attach the Seat Frame (36) to the Front Upright
(42) with the M10 x 80mm Carriage Bolt (99) and
the Seat Knob (49).
13. Press two 38mm Square Inner Caps (32) into the
ends of the Leg Lever (29).
Lubricate an M10 x 60mm Bolt (7). Attach the Leg
Lever (29) to the Seat Frame (36) with the Bolt
and an M10 Nylon Locknut (21). Do not over-
tighten the Nylon Locknut; the Leg Lever
must be able to pivot easily.
14. Press a 50mm Square Inner Cap (44) into the
end of the Left Butterfly Arm (47). Press a Sleeve
(105) into the round tube on the Left Butterfly
Arm.
Wet the lower end of the Left Butterfly Arm (47)
with soapy water. Slide a Large Foam Pad (45)
onto the Left Butterfly Arm.
Repeat this step with the Right Butterfly Arm
(not shown).
11
36
12
42
99
13
36
14
10
32
87
80
49
36
7
Lubricate
32
29
21
32
105
47
45
44