Weider 9250 User Manual page 11

15. Lubricate the axles on the Top Frame (55). Orient
the Right Butterfly Arm (48) as shown and slide it
onto the right axle. Make sure the Butterfly Arm
is behind the bracket on the Top Frame.
Have a second person secure the Right Butterfly
Arm (48) to the axle with two 25mm Retainers
(68) and a 25mm Cover Cap (65). Note: Place
the Retainers on top of the inverted Cover
Cap, as shown in the inset drawing; make
sure the teeth on the Retainers bend toward
the Cover Cap. Gently tap the Cover Cap onto
the axle.
Repeat this step with the Left Butterfly Arm
(47).
Cable Assembly
16. For cable identification and routing during
steps 16 to 44, refer to the CABLE DIAGRAMS
on page 25. Do not overtighten the locknuts
securing the pulley; the pulleys must be able
to roll easily.
Locate the High Cable (11), which has a ball on
one end and an eyelet on the other. Route the
eyelet end of the Cable up through the Top Frame
(55) and around a "V"-Pulley (6). Attach the
Pulley inside the Top Frame with an M10 x 75mm
Bolt (76), two 12.5mm Spacers (82), two M10
Washers (9), and an M10 Nylon Locknut (21).
17. Wrap the High Cable (11) around a "V"-Pulley (6).
Attach the Pulley and a Long Cable Trap (50) to
the bracket on the Top Frame (55) with an M10 x
60mm Bolt (7) and an M10 Nylon Locknut (21).
Make sure the Cable Trap is oriented to hold
the Cable in the groove of the Pulley.
15
16
17
21
11
55
Bracket
47
Lubricate
Axle
48
68
65
Axle
68
65
11
76
6
82
55
9
82
9
21
50
7
6
11
55