Installations - Sanyo VCC-XZ400P Instruction Manual

INSTALLATIONS

CAUTION:
Check that the installation location is strong enough to bear the camera before proceeding.
Setup location
Install in a location (such as underneath overhangs) that is not exposed to direct sunlight.
Install to a wall or ceiling with no unevenness in its surface.
If installing to a curved surface, round pillar or similar, use a special bracket (sold separately).
Setup
1
Use mounting screws (M8x4, sold
separately) to install the camera to the
wall or ceiling.
If routing the connection cord outside the
wall, install so that the connection cord hole
is facing downward, and pull the connection
cord out from the hole.
CAUTION:
Be sure to embed the mounting screws at
least 3 cm into the wall. If the screw holes
are too shallow, the camera mount may fall
down.
Mounting screw: M8
Connection cord hole
5
2
Adjust the position of the camera.
Use the hexagonal wrench (large,
accessory) to loosen the screws at the place
that you want to move, and then adjust the
direction of the camera.
After making the adjustment, securely
re-tighten the screws.
Maximum 90 degrees
(to prevent cord from twisting)
Screw tightening torque after adjustment:
2 N . m or more
Screw tightening torque after adjustment:
4.3 N . m or more