View Setting - Sanyo VCC-XZ400P Instruction Manual

VIEW SETTING

In the MAIN MENU, use the CURSOR button
(j or l) to move the cursor to the file
number (e.g. 1) for VIEW SETTING, then
press the SET button.
The selected image setting file (e.g. VIEW
SETTING 1 screen) will appear.
Operations of VIEW SETTING screen
Refer to the pages given in the table below for each function for details on setting the functions.
VIEW SETTING
(Function)
IRIS (See p27)
WHITE BALANCE
(See p31)
SHUTTER (See p33)
MOTION (See p34)
APERTURE
(See p37)
GAMMA (See p37)
Note: When each of the following functions is ON "F", it may be possible to use other function in
conjunction with it "E". View columns vertically to determine which functions can be used
together.
IRIS AUTO: SENSE UP (activated)
MANU: EI (ON)
SHUTTER LONG
SHORT
MOTION
There are 2 possible settings for IRIS, autoiris (AUTO) and manual iris
(MANU).
Three white balance methods are available: Auto trace white balance (ATW),
one-push automatic white balance (AWC), and manual white balance (MWB).
Sets the electronic shutter to either the fast shutter speed mode (SHORT) or
the slow shutter speed mode (LONG).
This function generates an alarm when a suspicious figure is detected. Each
of the settings will enable certain kinds of detection based on the natural
image (swaying trees, flickers of light, etc.). It is also possible to enable
zooming in on target objects and intruders that have unusual brightness
levels (moving, bright) or are fast-moving.
This setting emphasizes the target object profile (horizontally or vertically).
This setting enables contrast sensitivity to be boosted by controlling the
gamma characteristics. Three gamma controls are available: gamma
correction (ON), smart gamma correction 1 (SMART 1), and smart gamma
correction 2 (SMART 2).
F: Function is set T: Not allowable E: Allowable
You can set 9 different patterns with view
files.
Signifies that VIEW SETTING 1 is the
camera setting 1. The CURSOR button
(d or c) can be usedto select one of the
nine VIEW SETTING patterns (0 – 8).
Neither the mask function nor the motion
detector function can be used with image
setting file "0", so they will not appear as
options in the screen for pattern 0.
Operation
F T T T T
T F T T E
T T F T T
T T T F E
T E T E F
26