Password Setting; Privacy Mask Setting - Sanyo VCC-XZ400P Instruction Manual

PASSWORD setting

PASSWORD setting
A
You can lock the privacy masks in place as gray
patterns after they have been set. The password
requirement is initially set to OFF, but to begin
using it, you must enter the factory set password
"1234".
1
Use the CURSOR button (j or l) to
move the cursor to OFF for PASSWORD
LOCK in the PRIVACY MASK SETTING
screen. Then press the SET button.
The PASSWORD screen will appear.
2
Use the CURSOR button (jldc) to
enter the factory set password "1234",
and then press the SET button.
"OK" will appear.
3
Press the SET button again.
The PRIVACY MASK SETTING screen will
reappear "ON" will be blinking for
PASSWORD LOCK.
Note: If a different password is required, "NG"
will appear. Please carefully maintain the
password so that it will not be forgotten.
PASSWORD LOCK cancellation
B
For use when PASSWORD LOCK is ON
1
Use the CURSOR button (j or l) to
move the cursor to ON for PASSWORD
LOCK in the PRIVACY MASK SETTING
screen. Then press the SET button.
The PASSWORD screen will appear.
2
Use the CURSOR button (jldc) to
enter the factory set password "1234",
and then press the SET button.
"OK" will appear.
3
Press the SET button again.
The PRIVACY MASK SETTING screen will
reappear and "OFF" will be blinking for
PASSWORD LOCK.
Note: If a different password is required, "NG"
will appear. Please carefully maintain the
password so that it will not be forgotten.
16