Table of Contents
Advertisement
DECIMAL POINT/ROUNDING
The DECIMAL POINT is set by selecting from the following 4 options:
TO PROGRAM THE DECIMAL POINT
Example: Program the Decimal Point for Option $X.XX (two decimal places, normally used in the United States):
1.
Turn the key to the "PRG" (PROGRAM) position.
2.
If a PRG/Z Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the
[CHECK] key, or if you did not program a PRG/Z Manager Password, go to Step 3.
3.
ENTER (2), then PRESS the [-%/RA] key.
Important: In the REGISTER modes ("REG1" and "REG2") it is not necessary to press the decimal point
when ringing up a price. An error tone will sound if used.
ROUNDING is used to round off figures to the nearest whole numbers. Choose from the following 3 options to select the
rounding as needed:
Number
Example: Program Rounding to 50 (normally used in the United States):
1.
Turn the key to the "PRG" (PROGRAM) position.
2.
If a PRG/Z Manager Password has been programmed, ENTER the (PASSWORD #), then PRESS the
[CHECK] key, or if you did not program a PRG/Z Manager Password, go to Step 3.
3.
ENTER (50), then PRESS the [CHARGE] key.
Confirmation Report:
(zero decimal point)
(one decimal point)
(two decimal point)
(three decimal point)
"PRG" + (DECIMAL POINT #) + [-%/RA]
Selection
00
=
Rounds Numbers from .1 - .4 to 0
50
=
Rounds Numbers from .5 - .9 to 1 (U.S. Standard)
99
=
Rounds Numbers from .1 - .9 to 1
"PRG" + (ROUNDING #) + [CHARGE]
To check your results, a Program Confirmation Report is available. For details see Page 44.
Number
Selection
0
=
$ X
1
=
$ X.X
2
=
$ X.XX (U.S. Standard)
3
=
$ X.XXX
1 digit #
2 digit #
23
Hide quick links:
Advertisement
Table of Contents
