Regency Ceiling Fans Akina Owner's Manual page 2

g i
eneral nstallatiOn
I S
mportant afeguardS
1. To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before
beginning.
2. To avoid possible electrical shock, be sure electricity is turned off at the main power box before wiring. All
electrical connections must be made in accordance with local codes, ordinances and/or the National Electric Code. If
you are unfamiliar with the methods of installing electrical wiring and products, secure the services of a qualified and
licensed electrician as well as someone who can check the strength of the supportive ceiling members and make the
proper installation(s) and connections.
3. Make sure that your installation site will not allow rotating fan blades to come in contact with any object. Blades should
be at least 7 feet from floor.
4. When mounting on a ceiling outlet box, an approved box UL listed as "suitable for fan support" is required.
The box and its supporting members must be able to support the moving weight of the fan's listed weight.
The box must not be able to twist or work loose. Installation on a concrete ceiling should be performed by
qualified personnel.
5. Blades should be attached after motor housing is hung and in place. Fan motor housing should be kept in the carton
until ready to be installed to protect its finish. If you are installing more than one ceiling fan, make sure that you do
not mix fan blade sets, as each blade is part of a weighted set.
6. After making electrical connections, spliced conductors should be turned upward and pushed carefully up into outlet
box. The wires should be spread apart with the common conductor and the grounding conductor on one side of the
outlet box, and the "HOT" wires on the other side.
7. Electrical diagrams are for reference only.
8. After fan is completely installed, check to make sure that all connections are secure to prevent fan from falling and/or
causing damage or injury.
9. The fan can be made to work immediately after installation - the bearings are adequately charged with grease so that,
under normal conditions, further lubrication should not be necessary for the life of the fan.
10. To operate the reverse function on this fan, press the reverse button while the fan is running.
11. Please note that the total wattage of the uplights and an optional downlight cannot exceed 300 watts.
& O
peratiOn
:
i
nstruCtiOns
1