B Lade A Ttachment - Regency Ceiling Fans Akina Owner's Manual

B a
lade ttaChMent
B a
lade ttachment
1. Place fiber washer on screw. Insert this assembly through the blade and start the screw into the blade arm. Repeat this
procedure without tightening the screw until all 3 screws have been started into the blade arm (Fig. 1).
NOTE: Fans that have painted finishes may be packed with gaskets that can be used between the blade arm and blade
to help prevent a clicking noise that may develop if blade screws loosen over time.
2. Tighten each screw starting with center screw.
3 Fasten blade assembly to motor with provided screws and metal lockwashers (Fig. 2). Repeat procedure for
remaining blades. Make sure screws are TIGHT! Loose motor screws can contribute to unnecessary humming
and wobbling during operation.
NOTE: Cordless power screwdrivers
are NOT recommended, as they tend
to strip the heads of the screws and
usually will not fully compress the
spring washers on the motor screws.
Use a large flat blade screwdriver for
final tightening to fully compress the
spring washers. This will help ensure
proper alignment of the blades and
noise-free, wobble-free running.
Fan Motor
NOTE: Design of parts shown
above may look slightly different
F . 2
ig
for your specific model of fan.
:
Fiber Washer
Blade
F . 1
ig
Screw
Blade To Motor Screw
8
Blade Arm
Blade Assembly
Fig. 2