Removing The Duplex Unit - Epson AcuLaser C8600 Reference Manual

12. Plug the printer's power cord into an electrical outlet.
13. Turn on the printer.
To confirm that the Duplex Unit is installed correctly, print a
status sheet. If the unit is not listed on the status sheet, make sure
the electronic connectors connecting the Duplex Unit to the
printer are connected securely.

Removing the Duplex Unit

Follow these steps to remove the Duplex Unit:
1. Make sure the printer is not turned on, and unplug the power
cord if it is plugged into an electrical outlet.
2. Remove the face-up tray from the Duplex Unit output guide
on the left side of the printer.
3. Remove the connector cover and disconnect the cable of the
Duplex Unit output guide from the connector on the printer.
Then remove the Duplex Unit output guide.
4. Remove the plastic piece and disconnect the cable of the
inverter from the connector on the printer. Then loosen the
two screws to remove the inverter.
5. Reattach the cover (removed and stored during installation)
with the screws, then reattach the three small plastic pieces.
6. Remove the main unit of the Duplex Unit from the front of
the printer.
7. Reattach the Duplex Unit slot cover and fasten it with the
screw removed and stored during the installation procedure.
Using Options
7
7
7
7
7
7
7
7
7
7
7
7
225