Table of Contents
Advertisement
Appendix
Appendix
A strange sound is heard when
the vehicle comes close to a cer-
tain place (e.g. Dog barking).
Slope is not displayed on Vehi-
cle Dynamics screen.
"Inclination" does not move on
3D Calibration Status screen.
The person on the other end of
the phone call cannot hear the
conversation due to an echo.
Playback is not possible.
There's no picture.
The audio and video skip.
Rear display picture disappears. The source disc being listened to in
Problems in the AV screen (during disc playback)
Symptom
CD or DVD playback is not pos-
sible.
132
Engb
The sound for the entry of [Address
Book] is set.
The speed pulse lead is not con-
nected.
The voice from the person on the
other end of the phone call is output
from the speakers and then picked
up by the microphone again, creat-
ing an echo.
The disc is dirty.
The loaded disc is a type this unit
cannot play.
A non-compatible video system disc
is loaded.
The handbrake cord is not con-
nected.
The handbrake is not applied.
The navigation system is not firmly
secured.
the navigation system has been
ejected.
There was a problem with the rear
display or a faulty wiring connec-
tion.
The source without a video is se-
lected.
Cause
The disc is inserted upside down.
The disc is dirty.
The disc is cracked or otherwise da-
maged.
The files on the "CD (DVD)" are an
irregular file format.
The "CD (DVD)" format cannot be
played back.
The loaded disc is a type this system
cannot play.
Set the sound setting of that entry to [No
Sound]. (Page 60)
Connect the speed pulse lead.
Use the following methods to reduce the
echo:
—Lower the volume on the receiver
—Have both speakers pause slightly before
speaking
Clean disc.
Check what type the disc is.
Change to a disc compatible to your video
system.
Connect the handbrake cord, and apply the
handbrake.
Connect the handbrake cord, and apply the
handbrake.
Secure the navigation system firmly.
Before ejecting the disc, switch the source.
This problem may occur when certain con-
nection methods are used.
Check the rear display and its connection.
Switch the source with a video.
Action (See)
Insert the disc with the label upward.
Clean disc.
Insert a normal, round disc.
Check the file format.
Replace disc.
Check what type the disc is. Also see "Page
152" for more cautions about handling each
type of media.
Advertisement
Table of Contents
