NordicTrack Incline Trainer X9i Treadmill Manual page 10

2. Make sure that the power cord is unplugged.
Identify the right Upright (77), which has a wire
tie in it. Hold the Upright near the right side of
the incline trainer.
See the inset drawing. Tie the wire tie in the
right Upright (77) around the end of the Upright
Wire (78). Then, pull the other end of the wire tie
until the Upright Wire is routed out of the top of
the Upright.
3. Attach the Upright (77) to the Base (80) with
two 3/8" x 5 1/2" Screws (5) and a 3/8" x 2 3/4"
Screw (17) with three 3/8" Star Washers (8)
as shown. Start all three Screws, and then
tighten them. Be careful not to pinch the
Upright Wire (not shown) in the Upright.
Attach the other Upright (not shown) as
described above. Note: There is not a wire on
the left side.
2
Wire
Tie
78
77
3
77
80
10
Wire
Tie
77
78
5
8
8
17