NordicTrack Incline Trainer X9i Treadmill Manual page 15

10. See page 17 and plug in the power cord. Next,
see page 19 and turn on the power. See HOW
TO USE THE MAINTENANCE MODE on page
27 and calibrate the incline system of the
incline trainer. Then, touch the 1 Step Incline
button numbered 40 on the console. The Frame
(58) will adjust to an incline of 40 percent. Then,
turn off the incline trainer and unplug the power
cord.
Identify the Left Inside Cover (3) and the Left
Outside Cover (106). Next, hold the Left Inside
Cover against the left Upright (77). Then, hold
the Left Outside Cover against the Left Inside
Cover.
Attach the Left Outside Cover (106) to the Left
Inside Cover (3) with three #8 x 3/4" Screws (1).
Start all three Screws and then tighten them.
Attach the Right Inside Cover and the Right
Outside Cover (not shown) as described
above.
11. If necessary, move the incline trainer to the
desired location (see HOW TO MOVE THE
INCLINE TRAINER on page 30).
After the incline trainer is placed in the location
where it will be used, make sure that the incline
trainer rests firmly on the floor. If the incline
trainer rocks even slightly, turn the Leveling
Feet (14) as needed until the rocking motion is
eliminated.
12. Make sure that all parts are properly tightened before you use the incline trainer. Keep the included hex
keys in a secure place. One of the hex keys is used to adjust the walking belt (see page 32). To protect the
floor or carpet from damage, place a mat under the incline trainer.
10
1
1
11
15
58
77
106
3
14 14