NordicTrack Grt470 Manual page 16

33. Wrap the Ab Cable (74) around a 3 1/2Ó Pulley (24) in
the direction shown. Attach the Pulley and a Cable
Trap (25) to the indicated hole in the Press Frame (8)
with a 3/8Ó x 3 1/2Ó Bolt (56), a 3/8Ó Flat Washer (48),
and a 3/8Ó Nylon Locknut (50). Make sure that the
Cable Trap is oriented as shown.
Route the Ab Cable (74) back through the lower
opening in the Press Frame (8) as shown.
34. Wrap the Ab Cable (74) around a 3 1/2Ó Pulley (24) in
the direction shown. Attach the Pulley and a Cable
Trap (25) to the indicated hole in the Press Upright
(2) with a 3/8Ó x 3 3/4Ó Bolt (59), a 3/8Ó Flat Washer
(48) and a 3/8Ó Nylon Jam Nut (63). Make sure that
the Cable Trap is oriented as shown.
35. Remove both of the pre-assembled 3 1/2Ó Pulleys
(24) from the Adjustable Pulley Plates (23).
Wrap the Ab Cable (74) around a 3 1/2Ó Pulley (24) in
the direction shown. Attach the Pulley and a Cable
Trap (25) to the upper hole in the Adjustable Pulley
Plates (23) with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon
Locknut (50). Make sure that the Cable Trap and
the Adjustable Pulley Plates are oriented as
shown.
33
50
24
25
48
34
2
35
16
56
63
25
24
59
74
74
25
24
54
23
23
8
74
48
50