20. Wrap the Butterfly Cable (73) around a ÒVÓ-Pulley
(27) in the direction shown. Attach the ÒVÓ-Pulley and
a Large Cable Trap (32) to the welded bracket on the
back of the Butterfly Upright (1) with a 3/8Ó x 2 1/2Ó
Bolt (53) and a 3/8Ó Nylon Locknut (50). Make sure
that the Large Cable Trap is turned as shown.
21. Remove both 3 1/2Ó Pulleys (24) and Cable Traps
(25) from the pre-assembled Adjustable Pulley Plates
(23).
Wrap the Butterfly Cable (73) around a 3 1/2Ó Pulley
(24) in the direction shown. Attach the Pulley to the
top hole in the Adjustable Pulley Plates (23) with a
3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon Locknut (50).
Make sure the Cable Trap and the Adjustable
Pulley Plates are oriented as shown in the draw-
ing.
22. Wrap the Butterfly Cable (73) around a ÒVÓ-Pulley
(27) in the direction shown. Attach the ÒVÓ-Pulley and
a Large Cable Trap (32) to the welded bracket (not
visible in the drawing) on the back of the Butterfly
Upright (1) with a 3/8Ó x 2 1/2Ó Bolt (53) and a 3/8Ó
Nylon Locknut (50). Make sure that the Large Cable
Trap is oriented as shown.
23. Attach the Butterfly Cable (73) to the welded bracket
on the Right Butterfly Arm (10) with a 3/8Ó x 1Ó Bolt
(84) and two 3/8Ó Nylon Jam Nuts (63). Note: The
loop on the Cable and the two Nylon Jam Nuts
must be mounted underneath the welded bracket.
20
Welded Bracket
21
73
50
22
53
27
23
Welded
Bracket
10
73
12
32
1
25
23
24
23
Bracket
50
73
32
1
84
63
27
53
50
73
54