Page 1
1-888-825-2588 Pending Mon.–Fri., 6 a.m.–6 p.m. MST CAUTION Visit our website at Read all precautions and instruc- tions in this manual before www.nordictrack.com using this equipment. Save this new products, prizes, manual for future reference. fitness tips, and much more!
Limited Warranty ............. . . Back Cover Note: A Part List/Exploded Drawing is attached in the center of this manual. Remove the Part List/Exploded Drawing before beginning assembly. NordicTrack is a registered trademark of ICON Health & Fitness, Inc.
Important Precautions WARNING: To reduce the risk of serious injury, read the following important precau- tions before using the weight rack. 1. Read all instructions in this manual before 11. Always set both safety spotters at the same using the weight rack. Use the weight rack height.
Thank you for selecting the versatile NordicTrack ® have additional questions, please call our Customer GRT380 weight rack. Whether your goal is a shapely Service Department toll-free at 1-888-825-2588 figure, dramatic muscle size and strength, or a healthi- Monday through Friday, 6 a.m. until 6 p.m. Mountain...
Page 5
Part Identification Chart—Model No. NTBE05901 R1200A M8 x 30mm Bolt (22) M8 x 20mm Screw (33) Large Washer (28) M10 Nylon Locknut (7) M10 x 25mm Bolt (27) M10 x 65mm Bolt (26) M10 Washer (3) M10 x 70mm Bolt (29) M8 Washer (35) M10 x 90mm Bolt (9)
Assembly Before beginning assembly, carefully read the • For help identifying small parts, refer to the following information and instructions: PART IDENTIFICATION CHART on page 5. Note: Some small parts may be pre-assem- bled. Make Things Easier for Yourself! This manual is designed to ensure that the Assembly may require the following tools (not weight rack can be assembled successfully by included):...
Page 7
3. Slide a Brace (2) onto the bracket on one of the Uprights (1). Attach the Brace to the Upright with two M10 x 65mm Bolts (26), four M10 Washers (3), and two M10 Nylon Locknuts (7). Do not tighten the Nylon Locknuts yet.
Page 8
5. Press a 50mm Round Cap (34) into the end of a Weight Storage Tube (13). While a second person holds the Middle Crossbar (5) in the position shown, slide two M10 x 70mm Bolts (29) through the bracket on the Weight Storage Tube (13), the left Brace (2), and the bracket on the Middle Crossbar.
Page 9
8. Press a 25mm Bushing (31) into each end of the Locking Bar (20). Insert the Barbell (21) through the Locking Bar (20) until the Barbell is centered in the Locking Bar. 9. Identify the Left Weight Glider (18) by looking at the position of the round tube.
12. Place the right Safety Spotter (14) on the Right Base (4) and center it over the indicated hole. Note: The handle on the Right Spotter Hook (25) must point toward the center of the rack. Have a second person hold the Locking Bar (20) so that the Right Weight Glider (17) rests on top of the right Safety Spotter (14).
Page 11
Adjusting the Weight Rack This section explains how the weight rack is adjusted. See the included exercise guide for important information about how to perform a variety of exercises and how to get the greatest benefit from your exercise program. Inspect and tighten all parts each time you use the weight rack.
WHAT IS COVERED—The entire NordicTrack ® GRT380 weight rack (“Product”) is warranted to be free of all defects in material and work- manship. WHO IS COVERED—The original purchaser or any person receiving the Product as a gift from the original purchaser.
Page 13
REMOVE THIS PART LIST/EXPLODED DRAWING FROM THE MANUAL SAVE THIS PART LIST/EXPLODED DRAWING AND THE USER’S MANUAL FOR FUTURE REFERENCE...
Page 14
Part List—Model No. NTBE05901 R1200A Key No. Qty. Description Key No. Qty. Description Upright Barbell Brace M8 x 30mm Bolt M10 Washer Small Weight Clip Right Base Left Spotter Hook Middle Crossbar Right Spotter Hook Top Crossbar M10 x 65mm Bolt M10 Nylon Locknut M10 x 25mm Bolt Left Base...
Need help?
Do you have a question about the Grt380 and is the answer not in the manual?
Questions and answers