System Configuration; Changing The Basic Setting; Adding/Deleting Of Channels In The User List - TechniSat DigiCom 1 Operating Instructions Manual

½ Select the desired function with help of the cursor keys.
½ Confirm with OK.
Keep an eye on appearing messages on the screen.
5.6

System configuration

In this menu you will find the specific data of the receiver.
½ Call Main Menu with the MENU button.
½ Choose the menu line Settings by marking the corresponding line red with the
help of the cursor keys.
½ Confirm with OK.
The sub-menu Settings appears.
½ Choose the menu line System Configuration by marking the corresponding line
red with the help of the cursor keys.
½ Confirm with OK.
½ Leave the menu by pressing the MENU button.
6

Changing the basic setting

If you do not feel comfortable with the pre-programming of your receiver, you can
alter the programme list to your individual wishes. This function is also needed to sort
the channels after a channel search.
You should consider the following:
This unit has two channel lists: the user defined list and the complete channel list.
The user defined list contains all channels you can recall with the buttons of your
remote control.
The complete channel list contains all channels, those installed at the pre-
programming and those found during the channel search. New channels found
during a channel search are marked red in the list and can be copied into the user
defined list.
6.1 Adding / Deleting of channels in the user defined list
To add channels to or delete channels from the user defined list, proceed as follows:
½ Call Main Menu with the MENU button.
½ Choose the menu line TV Programs to select TV channels or Radio Programs to
select radio channels by marking the corresponding line red with the help of the
cursor keys up/down.
½ Confirm with OK.
The sub-menu Programs appears.
Main menu >Programs
Select
Sort
Lock
---------------------------------------------------------------------------------------
18