NordicTrack C 970 Pro Treadmill Manual page 15

12. Note: If assembled on a smooth surface, the
treadmill may roll forward during this step.
Raise the Frame (56) to the upright position.
Have a second person hold the Frame until
step 14 is completed.
Remove the two 5/16" x 3/4" Screws (4) from the
Latch Crossbar (38).
Orient the Latch Crossbar (38) as shown. Make
sure that the “"This side toward belt”" sticker
(C) is facing the treadmill. Attach the Latch
Crossbar to the brackets on the Frame (56) with
the two 5/16" x 3/4" Screws (4) that you just
removed and two 5/16" Star Washers (11).
13. Orient the Storage Latch (53) so that the decal is
facing away from the treadmill as shown.
Attach the lower end of the Storage Latch (53) to
the bracket on the Base (94) with a 5/16" x 1 3/4"
Bolt (6) and a 5/16" Nut (12).
Raise the Storage Latch (53) to a vertical posi-
tion. Then, remove and discard the tie (D).
12
11
4
56
13
D
Decal
12
15
Brackets
C
38
11
4
53
94
6