Installing The Driver Software In Windows 2000 - AVM FRITZ!Card PCI Installation Manual

2.5 Installing the Driver Software in
Windows 2000
Administrator rights are required to install the driver
software in Windows 2000.
Once the AVM ISDN-Controller FRITZ!Card PCI hardware has
been inserted in your computer, the next step is to install the
driver software for the ISDN-Controller. Proceed as follows:
1. Switch on your computer.
2. The "Found New Hardware Wizard" recognizes a new
Plug & Play device to be installed. Click "Next".
3. In the next window, select the option "Search for a suit-
able driver for my device (recommended)" and confirm
your selection with "Next".
4. In the next window, select the option "CD-ROM drives"
and confirm by clicking "Next".
5. The program reports that a driver was found. Click
"Next" to install the driver.
6. In the next dialog Windows may indicate that you are
about to install software not digitally signed by Mi-
crosoft. This prompt depends on the driver signature
options set on your computer. Answer the prompt with
"Yes". Repeat this procedure in the next dialog for the
AVM ISDN NDIS WAN CAPI Driver.
7. Conclude the installation by clicking "Finish".
Then a message that the FRITZ! communications software
can be installed appears. Continue with the section "Install-
ing the Communications Software FRITZ!" on page 17.

Installing the Driver Software in Windows 2000

FRITZ!Card PCI – 2 Installation 15