Yamaha TENERE XT660Z Owner's Manual page 20

INSTRUMENT AND CONTROL FUNCTIONS
Neutral indicator light "N"
This indicator light comes on when the
transmission is in the neutral position.
1
The electrical circuit of the neutral indi-
cator light can be checked by turning
2
the key to "ON". If the indicator light
does not come on for a few seconds,
then go off, have a Yamaha dealer
3
check the electrical circuit.
4
High beam indicator light "1"
This indicator light comes on when the
high beam of the headlight is switched
5
on. The electrical circuit of the high
beam indicator light can be checked
6
by turning the key to "ON". If the indi-
cator light does not come on for a few
seconds, then go off, have a Yamaha
7
dealer check the electrical circuit.
8
Coolant temperature warning
light "u"
This warning light comes on if the en-
9
gine overheats. If this occurs, stop the
engine immediately and allow the en-
10
gine to cool. The electrical circuit of the
warning light can be checked by turn-
ing the key to "ON". The warning light
should come on for a few seconds,
EAUB1520 and then go off. If the warning light
does not come on initially when the
key is turned to "ON", or if the warning
light remains on, have a Yamaha deal-
er check the electrical circuit.
NOTICE
Do not continue to operate the en-
gine if it is overheating.
EAUB1530
TIP
●
For radiator-fan-equipped vehi-
cles, the radiator fan(s) automati-
cally switch on or off according to
the coolant temperature in the ra-
diator.
●
If the engine overheats, see page
7-41 for further instructions.
EAU11444
Engine trouble warning light "U"
This warning light comes on or flashes
if a problem is detected in the electri-
cal circuit monitoring the engine. If this
occurs, have a Yamaha dealer check
the self-diagnosis system. (See page
4-8 for an explanation of the self-diag-
nosis device.) The electrical circuit of
the warning light can be checked by
turning the key to "ON". The warning
light should come on for a few seconds,
and then go off. If the warning light does
not come on initially when the key is
turned to "ON", or if the warning light re-
mains on, have a Yamaha dealer check
the electrical circuit.
ECA10021
Immobilizer system indicator
light "
The electrical circuit of the indicator
light can be checked by turning the
key to "ON". The indicator light should
come on for a few seconds, and then
go off. If the indicator light does not
come on initially when the key is
turned to "ON", or if the indicator light
remains on, have a Yamaha dealer
check the electrical circuit.
When the key is turned to "OFF" and
30 seconds have passed, the indicator
EAU11534
light will start flashing indicating the
immobilizer system is enabled. After
24 hours have passed, the indicator
light will stop flashing, however the im-
mobilizer system is still enabled.
This model is also equipped with a
self-diagnosis device for the immobi-
lizer system. (See page 4-8 for an ex-
planation of the self-diagnosis device.)
4-4
EAU26876
"