Adding Gear Oil - HUSABERG TE 125 EU Owner's Manual

17 SERVICE WORK ON THE ENGINE
17.5

Adding gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear of the transmission.
The gear oil must be added while the engine is cold.
Main work
–
Remove screw cap
Gear oil (TE 125)
Gear oil
(TE 250/300)
–
Mount and tighten the screw cap.
B00516-10
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
x
Preparatory work
–
Park the motorcycle on a level surface.
Main work
(TE 125)
–
Remove screw
602505-10
(TE 250/300)
–
Remove screw
B00496-11
–
Remove screw cap
–
Add gear oil until it emerges from the opening used to check the gear oil level.
Engine oil (15W/50) (
–
Mount and tighten the screw in the opening used to check the gear oil level.
Guideline
(TE 125)
Screw, gear oil level check
B00516-11
(TE 250/300)
Screw, gear oil level check
–
Mount and tighten screw cap
and fill up gear oil.
1
0.70 l (0.74 qt.)
0.80 l (0.85 qt.)
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
p. 97)
from the opening used to check the gear oil level.
1
from the opening used to check the gear oil level.
1
.
2
p. 119)
.
2
Engine oil (15W/50) ( p. 119)
Engine oil (15W/50) ( p. 119)
M6 10 Nm
(7.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)
99