Preparing For Rides On Dry Sand; Preparing For Rides On Wet Sand - HUSABERG TE 125 EU Owner's Manual

7 PREPARING FOR USE
7.4

Preparing for rides on dry sand

7.5

Preparing for rides on wet sand

–
Check the radiator cap.
Value on radiator cap
» If the displayed value does not equal the setpoint value:
600872-10
–
Change the radiator cap.
–
Fit a dust cover on the air filter.
Dust cover for air filter (59006019000)
Info
See the HUSABERG Pure Tech fitting instructions.
600869-01
–
Fit a sand cover on the air filter.
Sand cover for air filter (59006022000)
Info
See the HUSABERG Pure Tech fitting instructions.
–
Adjust the carburetor jetting and setting.
Info
600871-01
The recommended carburetor tuning is available from your authorized HUS-
ABERG workshop.
–
Clean the chain.
Chain cleaner (
–
Mount the steel sprocket.
Tip
Do not grease the chain.
–
Clean the radiator fins.
–
Straighten bent radiator fins carefully.
600868-01
–
If used in sand regularly, replace the piston every 10 operating hours.
–
Check the radiator cap.
Value on radiator cap
» If the displayed value does not equal the setpoint value:
600872-10
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling
system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse
immediately with lukewarm water.
p. 121)
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling
system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse
immediately with lukewarm water.
1.8 bar (26 psi)
1.8 bar (26 psi)
28