Installing The Shock Absorber - HUSABERG TE 125 EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.19

Installing the shock absorber

Main work
(TE 125)
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
602509-10
(TE 250/300)
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
602508-10
x
Main work
(TE 125)
–
Push splash protector
and tighten screw
Guideline
Screw, top shock
absorber
–
Mount and tighten screw
Guideline
602509-11
Screw, bottom shock
absorber
(TE 250/300)
–
Push splash protector
and tighten screw
Guideline
Screw, top shock
absorber
–
Mount and tighten screw
Guideline
602508-11 Screw, bottom shock
absorber
Finishing work
–
Remove the motorcycle from the lift stand. (
and lower the rear wheel with the swing arm as far as possible
1
, push splash protector
2
and lower the rear wheel with the swing arm as far as possible
1
, push splash protector
2
to the side and position the shock absorber. Mount
1
.
2
M12
.
3
M12
Info
The heim joint for the shock absorber at the swing arm is Teflon coated.
It must not be greased with grease or with other lubricants. Lubricants
dissolve the Teflon coating, thereby drastically reducing the service life.
to the side and position the shock absorber. Mount
1
.
2
M12
.
3
M12
Info
The heim joint for the shock absorber at the swing arm is Teflon coated.
It must not be greased with grease or with other lubricants. Lubricants
dissolve the Teflon coating, thereby drastically reducing the service life.
to the side, and remove the shock
3
to the side, and remove the shock
3
80 Nm Loctite ®
(59 lbf ft)
80 Nm Loctite ®
(59 lbf ft)
80 Nm Loctite ®
(59 lbf ft)
80 Nm Loctite ®
(59 lbf ft)
p. 44)
52
2701
2701
2701
2701