Handlebar Position; Adjusting The Handlebar Position - HUSABERG TE 125 EU Owner's Manual

10 TUNING THE CHASSIS
10.14

Handlebar position

10.15

Adjusting the handlebar position

1 1
1 0 0 1
2 0 0 2
2 0 0 2
On the upper triple clamp, there are two holes a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the position that is most comfortable for the rider.
800116-10
x
–
Remove screws
to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and tighten screws
B00375-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Mount and tighten screws
Guideline
Screw, handlebar clamp
15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar and lay it
1
. Remove the handlebar support.
2
M10
apart.
A
from the center.
B
40 Nm Loctite
(29.5 lbf ft)
.
1
M8 20 Nm
(14.8 lbf ft)
43
.
2
® 243™