SECTION 9—FRONT RIGGINGS
Raising/Lowering Elevating Front Riggings
NOTE: For this procedure, refer to FIGURE 9.6.
1. Perform one of the following:
• Raising ‐ Pull back on the release lever and raise front rigging to the desired height.
• Lowering ‐ Support front rigging with one hand away from the release lever. Push
release lever downward with other hand.
FIGURE 9.6 Raising/Lowering Elevating Front Riggings
Adjusting/Replacing Telescoping Front Rigging
Supports
NOTE: For this procedure, refer to FIGURE 9.7 on page 49.
NOTE: When adjusting the telescoping front rigging support depth, ensure the footplate does not
interfere with the caster wheel rotation.
NOTE: Telescoping front rigging supports may be extended up to 2‐inches from the wheelchair
frame in 1‐inch increments. This adjustment does not affect seat depth.
NOTE: When installing the front riggings support tubes, ensure that the hinge pins are on the
outside of the wheelchair facing away from the seat frame.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 36.
2. Remove the two socket bolts and locknuts that secure telescoping front rigging
support to the seat frame.
Pronto® M91™ with SureStep®
Release
Lever
48
Part No 1141450