Adjusting Seat Position On Seat Frame - Invacare Pronto M91 Owner's Manual

Adjusting Seat Position on Seat Frame

NOTE: For this procedure, refer to FIGURE 7.5 and FIGURE 7.7 on page 41.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 36.
2. Remove the four mounting screws and washers securing the seat assembly to the seat
frame (FIGURE 7.5).
3. Separate the seat assembly from the seat frame.
4. Refer to FIGURE 7.7 to determine the correct mounting holes to achieve the desired
seat position.
5. Align the seat assembly mounting holes determined in STEP 4 with the seat frame
mounting holes determined in STEP 4.
6. Using the four mounting screws and washers, secure the seat assembly to the seat
frame. Securely tighten.
7. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 36.
Seat Frame
Washer
Mounting
Screws
* DO NOT Use
Use these Mounting Holes for
1-inch-back Seat Position
Use these Mounting Holes
for Standard Seat Position
* DO NOT Use
Use these Mounting Holes
for 1-inch-back Seat Position
Use these Mounting Holes
for Standard Seat Position
*NOTE: Only the 22‐inch wide seats have these mounting holes. DO NOT use these mounting holes.
FIGURE 7.5 Adjusting Seat Position on Seat Frame
Part No 1141450
Bottom View of Seat Assembly
Front of Seat
DO NOT use
these mounting
holes.
Rear of Seat
39
SECTION 7—SEAT
Seat Assembly
Seat
Positioning
Strap
* DO NOT Use
Use these Mounting Holes
for 1-inch-back Seat Position
Use these Mounting Holes
for Standard Seat Position
* DO NOT Use
Use these Mounting Holes
for 1-inch-back Seat Position
Use these Mounting Holes
for Standard Seat Position
Pronto® M91™ with SureStep®