Installing; Adjusting The Seat Height - Invacare Pronto M91 Owner's Manual

2. Push down on the latch bar underneath front of seat.
3. Tilt front edge of seat up.
4. Slide the seat assembly forward to disengage seat from the pivot brackets located in
the rear.

Installing

1. Position the seat in the rear pivot brackets as shown in FIGURE 7.3.
2. Tilt front edge of seat down.
3. When seat is lowered, engage seat brackets into seat clevis pins.
When reinstalling the seat verify that the seat brackets are engaged with the seat
clevis pins by pulling up on the latch bar.
4. Pull up on latch bar to verify that brackets are engaged with seat clevis pins.
5. Connect the joystick. Refer to Disconnecting/Connecting the MK5 Joysticks on
page 69.
FIGURE 7.3 Removing/Installing the Seat Assembly

Adjusting the Seat Height

NOTE: For this procedure, refer to FIGURE 7.4 on page 38.
NOTE: The seat can be adjusted to five height positions in ½‐inch increments.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 36.
2. Remove the mounting screw and locknut that secures the adjustable height tube to the
support tube.
Part No 1141450
WARNING
Latch Bar
(located under the front of the seat)
37
SECTION 7—SEAT
Rear Pivot
Brackets
Seat Clevis Pins
Pronto® M91™ with SureStep®