Section 1-General Guidelines; Controller Settings/Repair Or Service; Accessories Information; Operation Information - Invacare Pronto M91 Owner's Manual

SECTION 1—GENERAL GUIDELINES
SECTION 1—GENERAL GUIDELINES
WARNING
SECTION 1 - GENERAL GUIDELINES contains important information for the safe
operation and use of this product.

Controller Settings/Repair or Service

Set‐up of the Electronic Control Unit is to be performed ONLY by a qualified technician.
The final adjustments of the controller may affect other activities of the wheelchair.
Damage to the equipment could occur if improperly set‐up or adjusted.
DO NOT service or adjust your wheelchair while occupied, unless otherwise noted.
Wheelchairs should be examined during maintenance for signs of corrosion (water
exposure, incontinence, etc.). Electrical components damaged by corrosion should be
replaced IMMEDIATELY.
Wheelchairs that are used by incontinent users and/or are frequently exposed to water
may require replacement of electrical components more frequently.

Accessories Information

Invacare products are specifically designed and manufactured for use in conjunction with
Invacare accessories. Accessories designed by other manufacturers have not been tested
by Invacare and are not recommended for use with Invacare products.
EXTREME care should be exercised when using oxygen in close proximity to electric
circuits and other combustible materials. Contact your oxygen supplier for instruction in
the use of oxygen.

Operation Information

Performance adjustments should only be made by professionals of the healthcare field or
persons fully conversant with this process and the driverʹs capabilities. Incorrect settings
could cause injury to the driver, bystanders, damage to the wheelchair and to
surrounding property.
After the wheelchair has been set‐up, check to make sure that the wheelchair performs to
the specifications entered during the set‐up procedure. If the wheelchair does NOT
perform to specifications, turn the wheelchair Off IMMEDIATELY and reenter set‐up
specifications. Repeat this procedure until the wheelchair performs to specifications.
ALWAYS shift your weight in the direction you are turning. DO NOT shift your weight
in the opposite direction of the turn. Shifting your weight in the opposite direction of the
turn may cause the inside drive wheel to lose traction and the wheelchair to tip over.
13
Part No 1141450 Pronto® M91™ with SureStep®