Inserting The Chassis Into The Rack - HP Cluster Platform Hardware Kits v2010 Installation Manual

Figure 4: Attaching the Left Retainer Bracket to the Interconnect Chassis
1
2
1. Identify the two screw hole locations, as shown in Figure 4. Depending
on which type of interconnect you are installing, use the following mount
locations:
a. To attach the bracket to a 5U (9-slot, 64-port) interconnect, use the screw
location indicated by callout 1. (The top round hole in the bracket.)
b. To attach the bracket to a 3U (5-slot, 32-port) interconnect, use the screw
location indicated by callout 2. (The elongated hole in the middle of the
bracket.)
2. Use a #1 Phillips screwdriver to secure the retainer bracket to the interconnect
chassis with 2 6-32 x .375 in Phillips screws.
3. Repeat steps 1 and 2 for the right retainer bracket.

9 Inserting the Chassis Into the Rack

You insert the interconnect chassis from the rear of the rack, with its front panel
(the connection ports) facing the rear of the rack, as shown in Figure 5. (All
cabling is done at the rear of the rack.)
_______________________
The HP 10642 rack is tall. To avoid injury, always use two people
and a stable, elevated work platform to lift any components at a high
position in the rack.
Rear of Interconnect
Chassis
Left Retainer
Bracket
WARNING
Myrinet Interconnect Rack Kit Installation Guide
______________________
5