Part Ii: Technical User's Guide - HP Carrier-grade cc2300 Product Manual

Part II: Technical User's Guide

4 Upgrading the Hardware
5 Upgrading the Chassis
6 Technical Reference
This section describes procedures that REQUIRE internal server access.
WARNING
Before removing the covers, see "Safety: Before You Remove Server
Covers" on page 64 and "Warnings and Cautions" on page 65.
WARNING
Do not attempt to modify or use an AC power cord that is not the exact
type required. You must use a power cord that meets the following
criteria:
1. Rating: For U.S./Canada cords must be UL Listed/CSA Certified type SJT,
18-3 AWG. For outside U.S./Canada cords must be flexible harmonized (<HAR>)
or VDE certified cord with 3 x 0.75 mm conductors rated 250 VAC.
2. Connector, wall outlet end: Cords must be terminated in grounding-type male plug
designed for use in your region. It must have certification marks showing
certification by an agency acceptable in your region and for U.S. must be rated
125% of overall current rating of the server.
3. Connector, server end: The connector that plugs into the AC receptacle on the
server must be an IEC 320, sheet C13, type female connector.
4. Cord length and flexibility: Cords must be less than 4.5 meters (14.76 feet) long.
5. Only use a screwdriver tip to push in the lock tabs on the rack slides.
A pinch hazard exists if fingers are used for this purpose.
cc2300 Carrier Grade Server Product Guide 61