2.
Enter interface view.
3.
Configure the line
rate for the interface.
Displaying and maintaining traffic policing, GTS,
and line rate
On the HP Blade 6125 Switch Series, you can configure traffic policing in MQC approach. For more
information about the displaying and maintaining commands, see
policies."
Task
Display interface GTS
configuration information.
Display interface line rate
configuration information.
Traffic policing configuration example
Network requirements
As shown in
GigabitEthernet 1/0/3 of Device A is connected to GigabitEthernet1/0/1 of Device B.
•
•
Server, Host A, and Host B can access the Internet through Device A and Device B.
Perform traffic control on GigabitEthernet 1/0/1 of Device A for traffic received from Server and Host A,
respectively, to satisfy the following requirements:
•
Limit the rate of traffic from Server to 1024 kbps: transmit the conforming traffic normally, and mark
the excess traffic with DSCP value 0 and then transmit the traffic.
Limit the rate of traffic from Host A to 256 kbps: transmit the conforming traffic normally, and drop
•
the excess traffic.
Perform traffic control on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 of Device B to satisfy the
following requirements:
Limit the total incoming traffic rate of GigabitEthernet 1/0/1 to 2048 kbps, and drop the excess
•
traffic.
Limit the outgoing HTTP traffic (traffic accessing the Internet) rate of GigabitEthernet 1/0/2 to 1024
•
kbps, and drop the excess traffic.
interface interface-type
interface-number
qos lr { inbound | outbound }
cir committed-information-rate
[ cbs committed-burst-size ]
Command
display qos gts interface [ interface-type interface-number ]
[ | { begin | exclude | include } regular-expression ]
display qos lr interface [ interface-type interface-number ]
[ | { begin | exclude | include } regular-expression ]
Figure
13:
N/A
N/A
37
"Displaying and maintaining QoS
Remarks
Available in any
view
Available in any
view