Configuring Wfq Queuing; Configuration Procedure - HP 6125G Configuration Manual
Acl and qos configuration guide
Hide thumbs
Also See for 6125G:
- Command reference manual (426 pages) ,
- Configuration manual (379 pages) ,
- Release note (60 pages)
Table of Contents
Advertisement
Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure WRR queuing on port GigabitEthernet 1/0/1.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wrr weight
[Sysname-GigabitEthernet1/0/1] qos wrr 0 group 1 weight 1
[Sysname-GigabitEthernet1/0/1] qos wrr 1 group 1 weight 2
[Sysname-GigabitEthernet1/0/1] qos wrr 2 group 1 weight 4
[Sysname-GigabitEthernet1/0/1] qos wrr 3 group 1 weight 6
[Sysname-GigabitEthernet1/0/1] qos wrr 4 group 1 weight 8
[Sysname-GigabitEthernet1/0/1] qos wrr 5 group 1 weight 10
[Sysname-GigabitEthernet1/0/1] qos wrr 6 group 1 weight 12
[Sysname-GigabitEthernet1/0/1] qos wrr 7 group 1 weight 14
Configuring WFQ queuing
Configuration procedure
To configure WFQ queuing:
Step
1.
Enter system view.
2.
Enter interface view.
3.
Enable byte-count or
packet-based WFQ
queuing.
4.
Configure the
scheduling weight for a
queue.
5.
Configure the minimum
guaranteed bandwidth
for a WFQ queue.
6.
Display WFQ queuing
configuration.
NOTE:
To guarantee successful WFQ configuration, make sure that the scheduling weight type (byte-count or
packet-based) is the same as the WFQ queuing type (byte-count or packet-based) when you configure the
scheduling weight for a WFQ queue.
Command
system-view
interface interface-type interface-number
qos wfq [ byte-count | weight ]
•
For a byte-count WFQ queue:
qos wfq queue-id group group-id
byte-count schedule-value
•
For a packet-based WFQ queue:
qos wfq queue-id group group-id
weight schedule-value
qos bandwidth queue queue-id min
bandwidth-value
display qos wfq interface [ interface-type
interface-number ] [ | { begin | exclude |
include } regular-expression ]
45
Remarks
N/A
N/A
The default queuing algorithm on
an interface is SP queuing.
Select a command according to
the WFQ type (byte-count or
packet-based) you have enabled.
If you have enabled WFQ on the
port, byte-count WRR applies by
default, and the default scheduling
weight is 1 for each queue.
Optional.
64 kbps by default for each queue.
Optional.
Available in any view
Advertisement
Table of Contents
