AXIS 1611 User's Manual
Notes:
5. Wait for the flash loading operation to finish. This normally
takes 1 minute. The AXIS 1611 automatically restarts with the
new software.
6. Log out using the command
your FTP version.
If the upgrading process fails, just repeat the instructions presented
•
above.
If you lose contact with the AXIS 1611 after an upgrading failure, just
•
restart the AXIS 1611 to restore contact.
If the Network LED flashes at regular half second intervals, the AXIS
•
1611 cannot process any print jobs. In order to leave this state, you
must repeat the instructions above.
Upgrading the Firmware
or
depending on
quit, bye
exit
43