Safety Notices - Axis 1611 User Manual

AXIS 1611 User's Manual
2

Safety Notices

Please read through the following safety notices before installing the AXIS 1611.
Caution! - implies that if not followed you may lose data or damage your equipment.
Important! - implies that if not followed the operation of the AXIS 1611 may be impaired.
Do not proceed beyond any of the above notices unless you have taken appropriate measures!
Electromagnetic Compatibility and VCCI
EMC - USA:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gen-
erates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
EMC - Europe:
This digital equipment fulfils the requirements for radiated emission according to limit B of EN55022, and the requirements for immunity according to
EN55024 residential, commercial, and light industry.
VCCI - Japan:
This is a class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Equipment (VCCI). If this
is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the
instruction manual.
Note for the use of USB cable:
This is a Class A product based on the a standard of the Voluntary Control Council for Interference by Information Technology Equipment(VCCI) when
connecting a USB cable to a printer. If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the
user may be required to take corrective actions.
VCCI - Australia:
This electronic device meets the requirements of the Radio communications (Electromagnetic Compatibility) Standard 1998 AS/NZS 3548
Liability
Every care has been taken in the preparation of this manual; if you detect any inaccuracies or omissions, please inform your local
Axis office. Axis Communications AB cannot be held responsible for any technical or typographical errors and reserves the right
to make changes to the product and manuals without prior notice. Axis Communications AB makes no warranty of any kind with
regard to the material contained within this document, including, but not limited to, the implied warranties of merchantability
and fitness for a particular purpose. Axis Communications AB shall not be liable nor responsible for incidental or consequential
damages in connection with the furnishing, performance or use of this material.
Axis' Trademarks
ThinServer, AXIS CAPT Print Monitor
Other Trademark Acknowledgments
Canon, Canon CAPT, DOS, Internet Explorer, Microsoft, Netscape, NetSpot, Windows, are registered trademarks of the respective holders.
| | | |
AXIS 1611 User's Manual Part no. 2001 Revision 1.1 Date: June 2003 Copyright © Axis Communications AB,
|
This manual applies to the AXIS 1611 with firmware version 5.92 and up.
1999-2003