Axis 1611 User Manual page 40

Management & Configuration
40
Performing a Hard
Factory Default
If you cannot access the AXIS 1611 internal web pages, you can
perform a hard factory default by following these steps:
Caution
Please follow these precautions when handling the AXIS 1611 Network Interface Card!
•
Be cautious when handling the AXIS 1611 Network Interface Card, as it contains sharp
components and angles.
•
The AXIS 1611 Network Interface Card contains components that are sensitive to static
electricity. Minimize static electricity when handling the AXIS 1611 Network Interface Card by
following these guidelines:
- Avoid touching material that generates static electricity when handling the AXIS 1611 Net-
work Interface Card, such as a computer display.
- Do not touch printed wiring and connectors on the AXIS 1611 Network Interface Card with
your fingers, hold the metal panel portion of the card when handling.
- Keep the AXIS 1611 Network Interface Card in its protective bag until installation. The
protective bag should be used when removing the AXIS 1611 Network Interface Card
from the printer and should not be discarded.
1. Turn OFF the printer.
2. Remove the network cable from the AXIS 1611 network
connector.
3. Remove the 2 screws from the expansion board slot.
4. Pull out the AXIS 1611 Network Interface Card from the slot.
Locate the 3-pin jumper with a cap on top:
DO NOT TOUCH
THESE PINS!
AXIS 1611 User's Manual
X
1
2
3-pin jumper
with cap