TEC MA-1535-2 series Owner's Manual page 13

5. DISPLAY
(3) Error Messages
When an error occurs, an error message (programmable) is displayed in the upper row, and an error
code is in the lower row with an error buzzer sound (a long tone). For the error messages and error
codes, see the table on the following page.
Refer to the following error message table to find the cause of the error. Press the [C] key to clear the
error status and stop the buzzer sound, remove the cause of the error, and then operate the sequence
again.
Error Error message
Code (Standard setting)
E04 OPTION RAM
E05 PRINTER
E11 FUNCTION
E12 CASHIER
E13 CTRL LOCK
E14 NO CASHIER
E16 REPORT REQ
E18 HALO
E19 LALO
E21 PR PAPER 1
E22 PR PAPER 2
E23 PR HEAD UP
E24 J PAPER 1
E25 J PAPER 2
E26 J HEAD UP
E32 CODE# REQ
E33 SUB-TL REQ
E34 AMOUNT REQ
E35 DRW OPEN
--- SP STATUS
--- SP ERROR
--- SP BUSY
--- NO RESPONS
--- RESPONS NG
--- EFT CANCEL
--- PIN ERROR
BANK RAM Error
Printer Error
Key Sequence or Operation Procedure Error
Cashier Error
Control Lock Error
No Cashier error
Report Request Error
High Amount Lock Out Error
The entered amount exceeds the pre-programmed upper limit.
Low Amount Lock Out Error
The entered amount is less than the pre-programmed lower limit.
Not used.
Receipt Paper End Error
The Paper Free Lever of the Receipt printer is raised.
Not used.
Journal Paper End Error
The Paper Free Lever of the Journal printer is raised.
Code Number Compulsory Error (Tender)
Sub-Total Key Compulsory Error (Tender)
Amount Compulsory Error
Drawer Open Error
The drawer must be closed before the operation.
Slip Printer Communication Error
Slip Printer Hardware Error
Slip Printer Busy
EFT Time Out Error
EFT Data Error
EFT Cancel
EFT Pin Pad Error
5- 2
5.1 Upper Row (10-digit Alphanumeric Display)
Cause of the Error
EO1-11149